Brief introduction to broken wall:
The broken wall is also called moving plate,which is also an important part of the cone crusher.It is often used to ensure the normal operation of the cone crusher together with the wall of the rolling mortar(fixed plate)and other parts.
Broken wall repair:
After being used for a period of time,due to the size of the discharge port,the outlet trench will be wore,which will cause the crusher to overheat,runout or high current and high load.
Remove the edges after wear (gas cutting), and then complete the welding repair. The damaged wall and mortar wall after repair shall be put into production without affecting the normal operation of the assembly and the machine .
Replacement of broken walls:
Broken walls can be replaced on site.Hoist out spindle parts,place them on strong support platforms,be careful not to damage moving cones and spheres,and block all oil holes with cloth to prevent dust from entering.Remove the distributor in turn,lock the nut,lock the gasket,and melt the gasket.The broken wall can be lifted out by welding two hoists at the position 180°apart from the old plate,and the installation of the new wall can also weld the two hoists at the position 180°above it.Then install in the opposite order of disassembly,and cut off the two suspenders when finished.
Suitable type: cone crusher